SPECIFICARE IN FASE DI PREVENTIVO COLORE E TIPOLOGIA FASCETTE
colori disponibili Blue Red , Black Green Yellow Purple Orange Matt Black ,
Variante disponibili No Stainless Steel W4 Worm-Drive Spring Clips (Out of stock) Stainless Steel W4 T-Bolt
Note: Some types of coolant are not compatible with silicone hoses. Please click here to download our Important Fitting Notes before buying and fitting silicone hoses.
This high quality reinforced silicone hose kit replaces the 4 intercooler hoses in the engine bay listed below. The kit removes the T-off to the standard noise generator on the cold side, improving performance by reducing the volume of air for the turbo to compress in the intake system. The stock resonator on the hot side can either be retained, or replaced with an aluminium/stainless pipe of 200mm length and 51mm outer diameter (not supplied).
Constructed with 4-ply reinforcing and thicker 5.4mm walls to prevent the hose from sucking in or collapsing under boost. The hoses fit N14 engine MINI Cooper S R55/R56/R57 (including JCW and Clubman Cooper S) models with the N14 engine only, it will not fit N18 engines.
Turbo to Resonator Hose
Resonator to Intercooler Inlet Hose
Intercooler Outlet to Hard Pipe Hose
Hard Pipe to Throttle Body Hose (replaces two original hoses and the plastic noise generator T-pipe)
Hose Clamps:
The kit is available with a full set of hose clamps using the options above. The three types of clamp we offer are shown below, but not all options will appear for some kits due to size limitations:
Spring clamps * Not available for this kit *
Worm-Drive clamps have slightly less evenly distributed clamping force as the Spring type clamps, but they are still a good quality clamp and usually easier to fit/remove in the tight confines of an engine bay. Being 100% stainless steel they do not rust, so we recommend this type of clamp if you are concerned about the appearance of your engine bay.
T-Bolt clamps are the most heavy duty clamps we supply, and are also 100% stainless steel to prevent rust. However they are much more expensive and, like the Worm-Drive clamps provide a slightly less evenly distributed clamping force than the Spring clamps. For this reason we recommend using them for Turbo applications (intercooler/intake hoses) where high boost can cause hose blow-off's and the additional clamping force is useful. Some customers like to use T-Bolt clamps for all hoses on their vehicle however so we offer them as an option for most of our kits.
For some vehicles the original clamps can be reused so we also offer our kits without clamps, but please be aware our silicone hoses are slightly thicker than the standard hoses so in some cases the original clamps may be too small.
Specification:Application: BMW MINI Cooper S (including JCW & Clubman) R55/R56/R57 MK2 Chassis '06-'12 | *N14 Engine only* 1.6 Turbo Prince Engine | Manual & Automatic Transmissions | RHD & LHD Models
Construction: ~5.4mm 5-ply silicone with 4-ply polyester reinforcing
Max Operating Pressure: >9bar
Burst Pressure: >12bar
Operating Temperature range: -50°c to 240°c
Certification: Manufactured to ISO9001:2000 & ISO TS16949 standards
Warranty: 3 Years (UK based)
3 piccole rate senza interessi. Fai shopping e risparmia. 
